Home  ›  Phones  ›  LG  ›

LG PM-325


Info Photos Reviews  66 News Forum  

all discussions

show all 7 replies

Questions and Concerns about the LG 325


Jan 25, 2005, 4:51 PM
Has anyone heard about an issue with the call ID not showing stored contact information if the area code was not used in storing the number?


Is there a charge issue, where the phone batterie is dead, but when plugged in the phone is reading fully charged?
Dot Man

Jan 25, 2005, 10:16 PM
I was told at a local Sprint store that the PM-325 is somehow disabled for modem use and can easily be enabled, but they would not pass on the information to do so.
Anyone know the solution?

Jan 26, 2005, 9:00 PM
I can use my PM-325 as a modem with my IPAQ 4150 handheld, but I have not been able to get it to work with my Sony VAIO VGN-T150P laptop.

Searching for an answer . . .

Feb 13, 2005, 2:32 PM

Could you post how the set up process went connecting your IPAQ with the LG 325? I just purchased the phone and have had no luck yet.


Apr 26, 2005, 8:31 PM
Don't know about the caller ID, I always use area codes in my phone because I live in a different area code than my phone is hooked up in.

I have had a problem with the battery dying and the phone turns off, then I plug it in and within a few seconds it shows completely charged. I still left it connected for a few hours to make sure though. It's only happened once, but I've only had the phone for a week. Anyone else?

Apr 28, 2005, 8:37 AM
i noticed this with my lg. to solve my issue i have had to turn my bluetooth off when i charge the phone. when i turn the bluetooth off the phone charges fine.

Oct 22, 2006, 10:30 AM
Yes, I've had this issue too with my LG phone (this model). It gets a bit annoying, and I noticed that the car charger just "quick" charges the phone so it cannot be depended on. The A/C charger though (wall charger) is a bit more reliable. I purchased my phone in December of 2005, and I believe that my battery is losing its ability to keep a charge as time goes one.

Jan 8, 2006, 3:52 PM
I have the same problem regarding caller id. Without the area code in the contact list, the phone does not recognize the number on an incoming call. Any way around this?

You must log in to reply.

Please log in to report a message to the moderator.

all discussions

Subscribe to Phone Scoop News with RSS Follow @phonescoop on Twitter Phone Scoop on Facebook Subscribe to Phone Scoop on YouTube Follow on Instagram


All content Copyright 2001-2018 Phone Factor, LLC. All Rights Reserved.
Content on this site may not be copied or republished without formal permission.